Search found 4 matches

Search found 4 matches Page 1 of 1
by Joss
Tue Apr 10, 2018 2:35 am
Forum: Viscosity Support (Mac Version)
Topic: Kill switch routing with IPv6: how?
Replies: 3
Views: 3907

Yes, thank you. I vaguely remember the route pre-down script.

But how do you do it in the routing table in Preferences > [Connection] > Network? It works perfectly for IPv4, no script needed, but how do we configure it for IPv6? (That was the question.)
by Joss
Fri Apr 06, 2018 2:49 am
Forum: Viscosity Support (Mac Version)
Topic: Kill switch routing with IPv6: how?
Replies: 3
Views: 3907

With IPv4 it's easy to configure a kill switch within Viscosity: (1) Preferences > Advanced: untick "Reset network interfaces on disconnect" (2) Preferences > Connections > [any connection] (2a) Advanced: add "remap-usr1 SIGTERM" (without the quotation marks of course) (2b) Networking > routing tabl...
by Joss
Mon Apr 02, 2018 3:10 am
Forum: Viscosity Support (Mac Version)
Topic: Viscosity support for DoH (DNS-over-HTTPS)
Replies: 1
Views: 3094

I've setup DNS in Viscosity for every connection, but I was wondering: how does Viscosity contact the resolvers in Full DNS mode? Of course the DNS request is sent through the VPN tunnel, but after exiting does it perform a DNS lookup on port 53? Or does it use DoH on port 443? If there's no DoH sup...
by Joss
Fri Jun 06, 2014 7:18 pm
Forum: Viscosity Support (Mac Version)
Topic: Access to earlier versions?
Replies: 11
Views: 6713

The direct link to 1.4.8 is still working: [removed by SparkLabs now a build is available below]

I have the same problems by the way with 1.4.9 and 1.4.10 (on Snow Leopard): connections to the VPN servers are established, but most websites don't load, incl. MacUpdate. ;)
Search found 4 matches Page 1 of 1