Only route a couple of IPs through VISCOSITY
Posted: Tue Sep 08, 2009 12:01 am
Hi there
I'm using a commercial VPN solution, and have just successfully set this up with Viscosity. However, all my traffic is currently being routed through my Viscosity connection. Ideally, I'd like to only have one or two IPs going through the VPN, and everything else going through my normal internet connection. I've unchecked "Send all traffic over network connection" in the networking tab.
I've tried entering Route (ip address), Mask (255.255.255.0) and vpn_gateway in the Networking tab, but all my traffic still gets routed through Viscosity, not just the IP address
Sorry for the noob question, but can anyone tell me what else I need to do to just route selected IPs through the VPN?
I'm using 1.0.5 and Leopard 10.5.8
Thanks
I'm using a commercial VPN solution, and have just successfully set this up with Viscosity. However, all my traffic is currently being routed through my Viscosity connection. Ideally, I'd like to only have one or two IPs going through the VPN, and everything else going through my normal internet connection. I've unchecked "Send all traffic over network connection" in the networking tab.
I've tried entering Route (ip address), Mask (255.255.255.0) and vpn_gateway in the Networking tab, but all my traffic still gets routed through Viscosity, not just the IP address
Sorry for the noob question, but can anyone tell me what else I need to do to just route selected IPs through the VPN?
I'm using 1.0.5 and Leopard 10.5.8
Thanks