Viscosity, PriTunl, and Pins
Posted: Sat Dec 21, 2019 4:21 am
Hello!
We've had a number of Mac users happily using Viscosity for some time, so when we rolled out a PriTunl based solution for different VPN environment they expected ( and succeeded at ) continuing to use Viscosity *except* when they've added a pin to their profile.
When a pin is set, the client goes into a failed authentication loop where it pops up a pin entry box then immediately fails and attempts a new connection, reminiscent of early 00s browser pop-up spam. We are unable to enter the pin
On instances with OTP enabled, we have the same issue - if it prompts ( sometimes it doesn't. The client just seems to loop.
Is this an issue with the configuration import I'm simply unable to spot? The only change I'm making to the import is unchecking use username and password.
Any suggestions?
We've had a number of Mac users happily using Viscosity for some time, so when we rolled out a PriTunl based solution for different VPN environment they expected ( and succeeded at ) continuing to use Viscosity *except* when they've added a pin to their profile.
When a pin is set, the client goes into a failed authentication loop where it pops up a pin entry box then immediately fails and attempts a new connection, reminiscent of early 00s browser pop-up spam. We are unable to enter the pin
On instances with OTP enabled, we have the same issue - if it prompts ( sometimes it doesn't. The client just seems to loop.
Is this an issue with the configuration import I'm simply unable to spot? The only change I'm making to the import is unchecking use username and password.
Any suggestions?