AWS VPN Routing

Got a problem with Viscosity or need help? Ask here!

jonesp123

Posts: 1
Joined: Fri Dec 18, 2020 10:42 pm

Post by jonesp123 » Fri Dec 18, 2020 10:49 pm
Hi,

I have Viscosity connect to my AWS VPN which has split tunneling enabled.

My internet traffic goes via my local gateway and anything on the AWS network goes via the AWS VPN.

I also want a few specific IP addresses to go via the VPN.

How can I achieve this?

So far I have tried adding it to the route table in Viscosity but that didn't seem to work.

Any help would be appreciated.

Thanks
Paul

Eric

User avatar
Posts: 1146
Joined: Sun Jan 03, 2010 3:27 am

Post by Eric » Mon Dec 21, 2020 10:51 am
Hi Paul,

Please take a read through the following - https://sparklabs.com/support/kb/articl ... lications/

If you don't think your routes are working, could you please post a copy of your route table and your configuration and what you are doing to test the route.

Regards,
Eric
Eric Thorpe
Viscosity Developer

Web: http://www.sparklabs.com
Support: http://www.sparklabs.com/support
Twitter: http://twitter.com/sparklabs
2 posts Page 1 of 1